Preformed Line Products Lite Tension Dead-end for ADSS AFL Mini Span 424

The FIBERLIGN Lite Tension Dead-end is a dielectric Dead-end designed to terminate short span, low tension ADSS fiber optic cables in low voltage environments. Unlike the Limited, Medium, and High Tension FIBERLIGN® Dielectric Dead-end designs, the Lite Tension Dead-end is reduced to a single layer component that offers an economical solution for very light loads. The product effectively transfers the low axial load on the cable at the end of the Dead-end legs to low uniform radial compression near the Dead-end loop

- Standard design parameters

- Broad cable OD ranges, listed on ID tags

- Economical single component design

- Optimized compact length

- Fast easy installation

- Accepts standard pole line fittings

- Latex coated with flared rod ends

- Uniform pressure design

- Superior fatigue strength wire design

-  The loop diameter of the Lite Tension Dead-end will fit over a minimum diameter of 1.5" (38mm) and a maximum diameter of 2-1/4" (57 mm)

- Short Spans: - 300' (91 m) maximum spans - not recommended for critical crossing spans (highways, rivers, etc.) see Medium or High Tension Dead-ends

- Cable diameter range is .415 to .459